5 Reasons Robot Mops Streak Hardwood Floors

The mop pad is too wet Robot mops dribble water onto a pad instead of spraying a fine mist. A soaked pad drags excess water across the wood, leaving a film that dries into streaks.

You’re using too much cleaning solution Residue from excess solution builds up on the floor. This creates a sticky film that shows as streaks once dry.

You didn’t squeeze out the pad first Attaching a wet pad straight from the wash guarantees too much water. Start with a damp pad by squeezing it out before use.

The water flow setting is too high If your robot lets you adjust water flow, set it to the lowest setting. Less water means fewer streaks.

You’re using a dirty pad A pad picks up dirt and grime as it cleans. Change pads every room, or flip to a clean side, to avoid spreading residue.